Perekayasaan mesin injeksi bakalan acuan sepatu secara sederhana
Abstract
Engineering of the injection molding machine to mold a master last made of plastics was done in the simple mechanism. Machine specification is a single screw, screw diameter 40 mm, ratio L/D = 24/1, heater 220/380 V. 700 W, motor 5,5 Hp, capacity 500 cm3/ minute.
INTISARI
Telah dilakukan suatu perekayasaan mesin injeksi sederhana untuk membuat bakalan acuan sepatu dari plastik. Mesin injeksi sederhana hasil rekayasa memiliki spesifikasi teknis sebagai berikut : jenis “Single Scren, diameter screw 40 mm, rasio L/D = 24/1, pemanas listrik 220/380 V dengan daya 700 W, motor induksi 5,5 Hp, kapasitas 500 cm3/menit.
Full Text:
PDFDOI: http://dx.doi.org/10.20543/mkkp.v10i19.439
Refbacks
- There are currently no refbacks.
Copyright (c) 2015 Agustin Suraswati, Pramono, Marwito Supriyadi, Supriyanto
This work is licensed under a Creative Commons Attribution 4.0 International License.
MKKP indexed by:
